Place Multiple

Matt_A · Post by **Matt_A** » Fri Jul 05, 2019 2:19 pm

Sometimes I have to assemble a sheet of photos. It would be nice to be able to select multiple files when using the Place... command, and be able to do it at one go. PowerCADD would place a stack of the files and then I would be able to arrange them to my liking. This would eliminate many clicks, and consequently save time.

Post by **todd@engsw.com** » Sun Jul 07, 2019 10:19 pm

That's a great idea, Matt! Shouldn't be too complex. I'll look into it.

Todd

Matt_A · Post by **Matt_A** » Mon Jul 08, 2019 12:26 pm

keeping my fingers crossed!